Whirlpool WDT750SAKZ Dimensions: Cutout Size and Door-Open Depth
Quick answer: Whirlpool’s WDT750SAKZ is 23⅞ inches wide and 33⅝ inches high at the planning guide’s minimum setting. That guide lists 26½ inches with the towel-bar handle and 50 3/16 inches with the door fully open. Whirlpool’s current product page lists 26¾ inches of depth, so a close installation needs a document-and-model check before ordering.
Measurements and what they mean
| Reference | What to do with it |
|---|---|
| Width | 23⅞ in; measure the narrowest point of the opening. |
| Minimum height | 33⅝ in; the guide makes this minimum conditional. |
| Closed depth, planning guide | 26½ in with towel-bar handle. |
| Closed depth, current product page | 26¾ in; use the larger listed value for a conservative borderline-space check until the exact revision is confirmed. |
| Door fully open | 50 3/16 in; standing/loading space is additional. |
How to handle the two closed-depth values
The planning guide and current Whirlpool product page differ by ¼ inch. This article does not invent a reason or average the values. If an island, drawer, or opposite door nearly touches the handle, send the seller or installer the full model number and ask which document applies to the delivered unit. Until then, compare the space with 26¾ inches and keep room for connections and the door.
The minimum height is conditional
The guide says the dishwasher can reach the 33⅝-inch minimum by removing the feet and the perforated insulation section where required. That is a condition in the planning document, not a promise that every delivered unit will slide into a 33⅝-inch opening. Measure from the finished floor to the lowest underside of the counter at the front and rear, and inspect the floor edge, trim, and protrusions.
Use this fit worksheet before ordering
Write down four measurements: opening width at its narrowest point; opening height at front and rear; depth to the first obstruction; and the clear distance from the rear reference to the fully open door. Then add a separate note for the person’s unloading space. A single “depth” number cannot answer all five checks.
- Corner: Whirlpool’s guide calls for at least 2 inches between the side of the open door and the adjacent wall or cabinet.
- Opposite an island: compare the 50 3/16-inch open-door reach with the available depth, then separately allow room for the person unloading.
- Replacement: flooring added after the old unit was installed can change both the height and the path needed to remove it.
The guide also lists 1 7/16 inches of leveling-foot extension. Treat that as a leveling range, not as a substitute for checking the opening or the installation procedure.
What to send the installer
Share width, height, and depth measurements together with photos of the floor edge, adjacent cabinets, handles, connections, and any drawer or refrigerator door that opens into the same space. Water, drain routing, electrical work, and securing the dishwasher must follow the installation instructions supplied with the appliance.
For owners of this same model
Read WDT750SAKZ cycles and options for choosing a wash program.
Sources and scope
- Whirlpool W11438541F Detailed Planning Dimensions Guide — model-family scope, conditional minimum height, open-door depth, corner clearance, and leveling range.
- Whirlpool WDT750SAKZ product page — current model identity and current 26¾-inch depth listing.
Source review: October 8, 2026. This is a manufacturer-document reference, not a hands-on installation test. Match the full model number and resolve the ¼-inch source discrepancy before a borderline installation.