Bosch SHP78CM5N Not Drying? CrystalDry Troubleshooting
The short answer: If your SHP78CM5N finishes but dishes are wet, first distinguish wet dishes from a wet tub wall. A damp interior wall can be normal according to Bosch. For wet dishes, check whether the chosen cycle has a drying phase, whether the rinse aid reservoir and dosage are set appropriately, and whether cups or containers trap water. The SHP78CM5N product page lists Crystal Dry as an option. The manual’s warning that some programs or options have a short or absent drying phase makes checking the actual selected combination the first step; that ordering is our interpretation of Bosch’s guidance. Bosch use-and-care manual, printed pp. 28–29; Bosch SHP78CM5N product page.
In this guide
- Identify the pattern
- A controlled check you can do at home
- Three common situations
- Fit and model links
- Frequently asked questions
Identify the pattern before changing settings
| Observation after a fully completed cycle | First check | What the result means |
|---|---|---|
| Tub walls are wet, dishes are acceptably dry | No repair step from that observation alone | Bosch says interior condensation droplets are normal. |
| Glass and ceramic are wet as well as plastics | Cycle and rinse aid | This is broader than plastic water retention; check the programmed drying phase and rinse aid supply. |
| Only concave cup bottoms or container lips hold pools | Rack angle and orientation | Water trapped in recesses cannot run off; tilt those items where safe. |
| Silverware has droplets where pieces touch | Spacing in basket or drawer | Bosch notes contact points can retain droplets. |
| Drying worsened after changing detergent tablets | Separate rinse aid and dispenser setting | Bosch says rinse aid within combination detergent may be less effective than a separate dose. |
This table is a reading aid built from Bosch’s troubleshooting list. It is not a fault-code decoder or a claim that CrystalDry hardware has failed.
A controlled check you can do at home
- Confirm the cycle actually ended. Bosch says early unloading can reduce the result and advises waiting until the program ends, then removing dishware 30 minutes afterward when evaluating drying. Use care: hot water or steam may escape if the door is opened during or just after a cycle. Manual, printed pp. 20 and 29.
- Record the selected program and options. Bosch lists Heavy, Auto, Normal, Speed 60 and Favorite on the SHP78CM5N product page, with Crystal Dry among its options. Some additional programs are available through Home Connect. A Favorite is a saved combination, so note which underlying program and options it recalls. Choose a program with a drying phase according to the manual rather than assuming every short program dries alike. Bosch product page; manual, printed pp. 10 and 28.
- Check rinse aid separately from detergent. Refill the rinse aid dispenser if needed and review its dosage setting in the manual’s rinse-aid section, printed p. 15. Bosch says too little or no rinse aid is a drying cause. A combination detergent tablet is not proof the separate dispenser has enough rinse aid. If your
r:setting isr:00, the manual says the rinse-aid system is off. Follow the setting instructions for your exact E-Nr.; avoid changing several settings at once. Manual, printed pp. 15–16 and 28–29. - Change only the load geometry for the next comparison. Angle dishwasher-safe cups and containers so recesses drain. Separate silverware that touches. Keep plastics only if their labels say dishwasher safe. Bosch’s manual attributes wet recesses and silverware contact droplets to how items sit in the rack. Manual, printed pp. 18 and 28–29.
- Run one comparable load and note the outcome. Use the same ordinary dishes, detergent and selected cycle while changing one suspected cause at a time. Record whether glass/ceramic, plastics, recesses or only tub walls remain wet. This comparison is an editorial diagnostic method; Bosch does not specify a home test score or guarantee an all-plastic dry result.
If broad wetness continues after the documented cycle, rinse-aid and loading checks, use Bosch support for the exact E-Nr. Avoid opening panels or attempting electrical or heating-component repairs from a wet-dish symptom.
Three common situations
“The tub wall is damp, but the plates are dry.” Bosch explicitly calls interior condensation after a wash normal. No drying repair is justified by wall moisture alone. Manual, printed p. 29.
“My glasses are wet after a quick cycle.” Confirm that the selected cycle and options provide a drying phase; Bosch lists an absent or short drying phase as a possible cause. Recheck with a drying-capable program before treating this as a machine failure. Manual, printed pp. 10 and 28.
“The dishes improved when I used a different tablet, then worsened again.” Check the separate rinse aid dispenser and its setting first. Bosch notes that the rinse-aid component of a combination detergent can have limited effectiveness. Change one variable at a time so the next result tells you something. Manual, printed pp. 15–16 and 29.
Fit and model links
This guide concerns performance after installation. For cabinet opening and connection planning, see the SHP78CM5N Dimensions guide. For an installation-space check, open the SHP78CM5N Fit Checker directly. Neither a fit result nor a drying symptom identifies a service part.
Frequently asked questions
Is CrystalDry a wash program?
Bosch lists Crystal Dry among the SHP78CM5N options, separately from programs such as Auto and Normal. Choose the wash program for the load and verify that the desired drying option is available for that combination. Bosch product page.
Is a wet interior wall a sign the drying system failed?
No. Bosch’s troubleshooting table says water droplets on the tub wall can result from normal condensation drying. Judge the dishware result separately. Manual, printed p. 29.
Can a detergent pod replace rinse aid?
Bosch says the rinse-aid component of combination detergent has limited effectiveness and recommends separate rinse aid for better drying. Check the separate dispenser and its dosage setting. Manual, printed pp. 15–16.
Should I clean the filter to fix wet dishes?
Bosch’s drying checklist starts with cycle, rinse aid, loading and timing. A dirty filter needs cleaning if the machine shows a filter warning or cleaning is otherwise due, but wet dishes alone do not prove a blocked filter. The manual assigns E:92-40 to soiled or blocked filters. Manual, printed pp. 24 and 27–29.
Source locations: Bosch SHP78CM5N use-and-care manual 9001641455_A, printed pp. 10 (cycles), 15–16 (rinse aid), 18 (loading), 20 (hot steam caution), 27 (E:92-40), 28–29 (drying troubleshooting); Bosch U.S. SHP78CM5N product page (exact model, listed programs and options). This is a manufacturer-source interpretation, not a hands-on performance test.