Samsung WF45T6000AW Self Clean+ and Pump Filter Guide
The short answer: Use the washer’s empty-drum cleaning cycle for residue and odor; clean the drain pump filter separately for trapped debris or slow drainage. The cleaning cycle does not remove lint or objects from the filter. Samsung’s WF45T6000AW/A5 product page markets the feature as Self Clean+, while the WF45T6000A* manual, printed p. 41 labels the cycle SELF CLEAN. Use the name printed on your actual control panel. The filter procedure is on printed pp. 43 and 45–46 of that manual.
In this guide
- Choose the right task
- Run the empty-drum cleaning cycle
- Clean the pump filter
- If cleaning does not resolve the problem
- Fit and model links
- Frequently asked questions
Choose the right task before opening anything
| What you notice | Start here | Why |
|---|---|---|
| Drum smells stale or has visible residue, but drains normally | Empty-drum cleaning cycle labeled Self Clean or Self Clean+ on your panel | The manual assigns this cycle to residue and odor inside the drum. |
| Drain is slow, 5C appears, or the lower filter has not been checked recently | Cool and drain the machine, then clean the pump filter | The manual ties a clogged drain filter to 5C. |
| Water remains in the drum after a power failure | Emergency-drain procedure before removing laundry or the filter | Opening the filter while the drum is full can release more water than a towel can hold. |
| Detergent residue remains in the drawer | Clean the drawer and its recess | This is a separate maintenance task; an empty-drum cycle does not physically clean the drawer. |
These are first actions, not a diagnosis of a failed part. If a leak, electrical smell, damaged cord, or an unresolved drain fault is present, stop using the machine and contact Samsung service.
Run the empty-drum cleaning cycle
- Remove every item from the drum. The manual warns that laundry left in during SELF CLEAN may be damaged.
- Press Power, turn the cycle selector to the Self Clean/Self Clean+ position shown on your panel, and hold Start/Pause (Hold to Start). The cited manual calls this position SELF CLEAN and says its hot water temperature is fixed. If your panel or supplied manual differs, follow the instructions supplied with your unit.
- Ordinarily run it without detergent or other chemicals. Only when residue is present, the manual permits liquid chlorine bleach up to the MAX line in the main-wash compartment, not the separate bleach compartment. Do not exceed MAX or mix in other chemicals. Follow the bleach label and keep children away from chemicals.
- If residue remains after the cycle, the manual allows an empty RINSE+SPIN cycle. Wipe moisture from the door area and leave the door ajar when the washer is idle, where safe to do so.
The cited manual calls for the cleaning cycle at least monthly or every 40 cycles. After 40 washing cycles, its reminder flashes for an hour and recurs for five more cycles; the reminder does not mean you must stop a current load. Samsung manual, printed p. 41.
Clean the pump filter without flooding the floor
Do this only after the water has cooled. Samsung’s U.S. support says to wait an hour after a hot Self Clean, Pure Cycle, or Sanitize cycle before opening the filter area. Turn the washer off and unplug it. Place a wide, shallow container and towels under the lower access cover. If the drum holds water, expect more than the small amount left after an ordinary cycle. Samsung U.S. cleaning guidance; Samsung manual, printed pp. 43 and 45–46.
- Press the top of the lower filter cover gently to open it. Extend the small emergency drain tube into the container while holding its cap.
- Open the tube cap and drain in batches if needed. Replace the cap and return the tube once flow stops. Do not turn the large filter knob first.
- Turn the drain filter knob counterclockwise and remove it. On some versions, a safety knob needs a push and turn. Keep the pan underneath for remaining water.
- Brush debris from the filter with a soft brush. Check the impeller area inside the opening for visible debris without dismantling the pump or reaching into energized parts.
- Reinsert the filter and turn the knob clockwise until it is properly closed. Refit the drain tube cap and cover. Check for water at the cover during the next normal use; stop if it leaks.
The current manual says to clean the drain filter five or six times a year. Samsung’s general U.S. support recommends at least monthly or approximately every 40 washes, whichever is more frequent. Those are different published intervals. For routine care, the more frequent U.S. support schedule is a conservative choice; the instructions supplied with your exact machine govern the hardware steps. Samsung manual, printed pp. 45–46; Samsung U.S. support.
If cleaning does not resolve the problem
If 5C returns, the manual calls it a drain-system issue. Check the filter again and inspect the visible drain hose for kinks or obstruction. The manual’s troubleshooting table also asks you to confirm that the house drain is clear; a persistent restriction needs service. 4C is a water-supply issue, not a reason to open the drain filter. The manual points to taps, supply hoses, and inlet screens for that code. Do not replace a pump from an error code alone. Samsung manual, printed pp. 44, 51 and 55.
Fit and model links
This cleaning guide assumes the washer is already installed. For body size, door swing and installation clearance, use the WF45T6000AW Dimensions guide. To check a new laundry space, open the WF45T6000AW Fit Checker directly. The checker addresses documented space measurements; confirm connections and the full model suffix separately.
Frequently asked questions
Does SELF CLEAN clean the pump filter?
No. The manual has separate procedures for the empty-drum cycle and physically removing debris from the filter. A 5C code calls for a drain check.
Is the label Self Clean or Self Clean+?
Samsung’s exact WF45T6000AW/A5 product page says Self Clean+; the cited WF45T6000A English manual says SELF CLEAN*. We cannot resolve the physical panel label from those two documents. Follow your machine’s actual control label and its supplied manual.
Can I add detergent or vinegar to SELF CLEAN?
The cited model manual says not to use or mix other detergent or chemicals during SELF CLEAN. It permits liquid chlorine bleach only under the residue condition and compartment/level instructions above. It does not direct you to add vinegar.
Why does the filter cover leak after cleaning?
The manual warns that a filter knob left open or an improperly inserted filter can leak. Turn the machine off, unplug it, and check that the filter and emergency tube cap are seated. If leakage continues, stop using it and seek Samsung service.
Source locations: Samsung WF45T6000AW/A5 product page (exact model and Self Clean+ marketing name); Samsung WF45T6000A* user manual DC68-04006R-07, cover (model family), printed p. 41 (SELF CLEAN), p. 43 (emergency drain), pp. 45–46 (drain filter), pp. 50–51 and 55 (troubleshooting); Samsung U.S. cleaning guidance (pump-filter interval and hot-water caution). This is a source-based guide, not a hands-on repair test.