Samsung WF45T6000AW Dimensions: Depth, Door Clearance and Stacking Kit

Quick answer: The Samsung WF45T6000AW is 27 inches wide, 38¾ inches high, and 31⅜ inches deep with the door closed. Samsung lists 52 11/16 inches from the washer’s back reference with the door open 90°. For a washer-only floor installation, the page-2 drawing shows 1 inch at each side and above, 5 15/16 inches behind, and 1 inch in front. Samsung’s footnote says the rear clearance can be reduced to 5 inches only when the washer feet are fully extended. These are installation clearances, not the entire loading area.

Measurements that decide the layout

Samsung WF45T6000AW specification-sheet and owner-manual values.
Reference What to use it for
Appliance width 27 in; check the side-clearance requirement separately.
Height without pedestal 38¾ in; a pedestal or stacked dryer changes the final configuration.
Closed depth 31⅜ in; measure from the installed back, including the connection path.
Door open 90° 52 11/16 in from the washer’s back reference; usable standing space is additional.
Washer-only clearances 1 in sides, 1 in above, 5 15/16 in behind normally, and 1 in in front. Samsung’s page-2 footnote permits 5 in behind only with the washer feet fully extended.
Samsung WF45T6000AW size and door clearanceFront view: 27 inches wide and 38 and three quarter inches high. Side view: 31 and three eighth inches deep with door closed, 52 and eleven sixteenth inches with door open 90 degrees. Rear installation space is additional.WF45T6000AW · size guide27 in38¾ inheightDepth: measure from the back31⅜ indoor closed52 11/16 in · door open 90°Schematic only · rear space is extra
Original diagram based on Samsung’s published dimensions. The open-door line starts at the back of the washer, not at the room wall. The drawing is not to scale.

Do not plan from 27 inches alone

Adding Samsung’s 1-inch side clearances to the 27-inch appliance width gives a 29-inch calculated planning width. A 28-inch opening is below that washer-only width reference. A 29-inch opening matches the arithmetic width check, but it does not establish a complete fit: verify height, rear connections, door swing, loading space, and the delivery route.

The open-door dimension starts at the washer’s back reference, not at the laundry-room wall. Using Samsung’s drawing value, 5 15/16 + 52 11/16 = 58 5/8 inches is the calculated normal wall-to-open-door reach. Only under the page-2 footnote condition—washer feet fully extended—does the conditional calculation become 5 + 52 11/16 = 57 11/16 inches. Neither arithmetic result promises comfortable standing or basket space; check the room door, trim, adjacent handles, and the person’s working position separately.

Washer-only versus a washer-and-dryer closet

Samsung’s specification sheet separates the washer-only installation from the pair’s closet-door ventilation arrangement. When the washer and dryer are installed together, the sheet calls for two unobstructed openings totaling at least 72 square inches, shown as 48 square inches above and 24 square inches below. Use the dryer and stacking instructions too; do not reuse the washer-only rear allowance for the entire pair.

Configuration check: Record one of these before ordering: washer only, washer on WE402NW pedestal, or stacked with SKK-8K. For the washer-only rear check, write down 5 15/16 in as the normal drawing value; use 5 in only if the washer feet are fully extended as Samsung’s footnote requires. Then recheck final height, rear connection space, door reach, and the applicable dryer/stacking ventilation instructions. The 27-inch cabinet-width check cannot establish accessory compatibility.

Measure your room in three passes

  1. Opening and route: measure the tightest cabinet point, baseboards, door trim, countertop overhang, hallway turns, and delivery route.
  2. Rear and door reach: allow the connection space first, then mark 52 11/16 inches from the installed back of the washer. Use 5 15/16 in rear space for the normal drawing calculation, or document the fully-extended-feet condition before using 5 in. Leave usable room beyond the door for loading.
  3. Final configuration: write down the pedestal or stacking choice before comparing height and ventilation. A stacked dryer is a different installation than a washer alone.

Accessory and model-code check

Samsung lists SKK-8K as the stacking kit, WE402NW as the white pedestal, and WE272NW as the white riser. The sheet also lists matching dryer families including DVE45T6000W/DVG45T6000W and the long-vent DVE45T6020W/DVG45T6020W. Confirm both complete model codes and the kit instructions before ordering; a dimension match alone does not establish compatibility.

Once the washer is installed

See the WF45T6000AW cycle guide for Quick Wash, Spin Only, and everyday controls.

Samsung WF45T6000AW: operation, care, and troubleshooting

For an installation-space check, open the KBeautyVibe Model Finder, search WF45T6000AW, select this model, and choose Check installation space. The checker compares documented dimensions; confirm utilities and site conditions separately.

Controls and settings

Spin Only

Hold Spin for 3 seconds to select Spin Only. Rinse+Spin is a separate choice when a rinse is needed.

Official source: Samsung Electronics — WF6000T English user manual DC68-04006R-07.

Quick Wash

Use for a lightly soiled load of 4 lb or less, as described in the WF6000T manual.

Official source: Samsung Electronics — WF6000T English user manual DC68-04006R-07.

Maintenance and cleaning

Self Clean+

Run Self Clean+ with an empty drum; Samsung's front-load cleaning guidance explains the cycle and pump-filter care.

Official source: Samsung Electronics America — Official Samsung product page; Samsung Electronics America — Official washer cleaning guidance.

Pump-filter interval

Samsung recommends cleaning the front-load pump filter at least monthly or about every 40 washes, whichever is more frequent. Let water cool after a hot cycle before draining the filter.

Official source: Samsung Electronics America — Official washer cleaning guidance.

Symptom-by-symptom checks

No or slow fill (4C)

  1. Confirm the water supply is available.
  2. Disconnect power and water before inspecting the inlet-filter screens using Samsung instructions.

If it persists: If 4C persists, use Samsung service guidance.

Official source: Samsung Electronics America — Official washer error-code guidance.

Documented error codes

4C

Water supply problem. Check the water supply and inlet-filter screens; disconnect power and water before filter work.

Manual location: Samsung 4C troubleshooting support.

Official source: Samsung Electronics America — Official washer error-code guidance.

Samsung WF45T6000AW: fit and controls FAQs

Samsung's cited U.S. documents identify the washer as WF45T6000AW/A5. Match that complete suffix and the manual revision to the rating label before choosing an accessory or relying on a control sequence.

What are the washer and door-open dimensions?

The WF45T6000AW is 27 in W × 38 3/4 in H × 31 3/8 in D. Samsung lists 52 11/16 in depth with the door open 90 degrees, measured from the washer's back reference, before adding rear clearance or standing room. Samsung specification sheet, pp. 1–2.

How much room should be left behind it?

The washer-only drawing shows 5 15/16 in behind. Samsung allows 5 in only with the washer feet fully extended; it also shows 1 in at each side, above and in front. Check hose routing and the actual enclosure. Samsung specification sheet, p. 2 and footnote.

Does a 29-inch opening guarantee fit?

No. Twenty-seven inches of body width plus two 1-inch side allowances equals a 29-inch arithmetic check. Height, rear connections, door swing, access and any pedestal or stacked dryer still need separate review. Samsung specification sheet, p. 2.

How do I start Spin Only?

The WF6000T owner's manual instructs users to hold Spin for 3 seconds to select Spin Only. Rinse+Spin is a different choice when the load also needs a rinse. Samsung user manual DC68-04006R-07, cycle controls.

When should Quick Wash be selected?

The manual describes Quick Wash for a lightly soiled load of 4 lb or less. For bulky or heavily soiled items, choose the cycle based on the care label and the manual's cycle chart. Samsung user manual DC68-04006R-07, cycle guide.

Why is a temperature or spin setting unavailable?

Available temperature, rinse, spin, soil and option combinations depend on the selected cycle. Choose the cycle first, then consult the chart for the setting that remains available. Samsung user manual DC68-04006R-07, cycle chart.

Can I assume a stacking kit fits from the width alone?

No. Confirm the full washer and dryer model codes and the kit specified for that pair. The washer-only clearance drawing does not establish a stacked installation's height or ventilation requirements. Samsung specification sheet, installation drawing.

Sources and scope

Source review: October 8, 2026. This is a manufacturer-document reference, not a hands-on test. Match the full model code and manual revision to the appliance.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *