Whirlpool WTW5057LW Dimensions: Width, Depth and Lid-Open Height

Quick answer: The Whirlpool WTW5057LW is 27¾ inches wide and 27 inches deep. Overall height is 41½–42¼ inches with its leveling feet. For a shelf above it, use the more important measurement: 55¾–56⅜ inches with the lid open. The cabinet depth alone does not include hoses, the drain route, or closet space.

Dimensions at a glance

Inch measurements from Whirlpool guide W11428629A, pages 2–4.
Reference What to know
Width 27¾ in (27.75 in)
Body depth 27 in; allow separate room for connections
Overall height with feet 41½–42¼ in
Height with lid open 55¾–56⅜ in
Recommended rear spacing 5 in in the closet/recess diagram
Recommended side spacing 1 in each side in the diagram
Closet-door ventilation shown 48 sq in upper openings and 24 sq in lower openings
WTW5057LW: 27¾ inches wide, 27 inches deep, and up to 56⅜ inches tall with the lid open. Schematic, not to scale.Check above the washerLid open55¾–56⅜ in27¾ in wide27 in deep
Original schematic based on Whirlpool’s planning guide. Not to scale; lid-open height varies with leveling. The table separates body measurements from room clearances.

Will it fit beneath your shelf?

Measure from the finished floor to the lowest obstruction, including shelf brackets. Compare that measurement with the lid-open height, not just the control-panel height. A shelf at 54 inches is below even the guide’s 55¾-inch minimum open-lid height, so it is not a workable comparison based on the published range.

If the underside is at 57 inches, the difference from the maximum listed open height is only ⅝ inch. That is a calculated difference, not an installation allowance. Check the actual leveled position and whether you can load bulky laundry comfortably.

Whirlpool reports testing with zero side clearance, but recommends extra room for installation, servicing and noise reduction. The illustrated side allowances make the width 29¾ inches (29.75 in): 27¾ (27.75) + 1 + 1. This is a calculated planning envelope, not a new Whirlpool cutout specification.

54-inch shelf

Below the 55¾–56⅜-inch open-lid range. Do not plan to use this space without changing the obstruction.

57-inch shelf

Only ⅝ inch above the listed maximum. Treat that as a calculation to verify, not as usable installation allowance.

29¾-inch width

27¾-inch body plus 1 inch on each side. It is a planning envelope, not an official cutout dimension.

Tight closet

Use the 5-inch rear diagram allowance, side space, hose bends, drain route, and the 48/24-square-inch ventilation openings together.

Fit worksheet: record the tightest measurement

Write the smallest usable value after measuring at the front, back, and lowest obstruction.
Measure this Record and compare
Opening width Front: ____ in; rear: ____ in. Body is 27¾ in (27.75 in); 29¾ in (29.75 in) is the calculated 27.75 + 1 + 1 planning envelope.
Floor to shelf or obstruction Lowest point: ____ in. Compare with 55¾–56⅜ in lid-open height; 54 in is below the published range.
Usable depth To the actual obstruction: ____ in. Add hose, valve, drain, and closet-door space to the 27-in body depth.
Rear and side space Rear: ____ in; each side: ____ in. The guide’s closet diagram shows 5 in behind and 1 in each side.
Closet ventilation Upper openings: ____ sq in; lower openings: ____ sq in. The diagram shows 48 upper and 24 lower.
Delivery route Doorways, turns, stairs: ____________________. A clear laundry opening does not prove the route is clear.

Reader decision: If the smallest measurement is below the applicable reference, or the space is close enough that leveling and connections could change it, pause the order and ask the installer to check the actual opening. This page identifies fit questions; it does not approve an installation.

Before ordering or relocating it

Take one photo of the space and another showing the plumbing and outlet. Mark the shelf height and available width on your notes so the installer can assess them together. The guide specifies 120 V AC, 60 Hz and a minimum 15 A circuit rating; the installation instructions govern the complete electrical and drain requirements.

Measure doorways and tight turns before delivery. If a measurement is close, have the installer check it before changing cabinetry.

For owners of this same model

See WTW5057LW Deep Water, PreSoak and Quick Wash for choosing settings after installation.

Whirlpool WTW5057LW: operation, care, and troubleshooting

For an installation-space check, open the KBeautyVibe Model Finder, search WTW5057LW, select this model, and choose Check installation space. The checker compares documented dimensions; confirm utilities and site conditions separately.

Controls and settings

Deep Water Wash and PreSoak

Both are listed options for WTW5057LW. Available cycle combinations depend on the control guide; do not assume a fixed fill level or universal pairing.

Official source: Whirlpool Corporation — WTW5057LW model comparison and cycle list.

Removable agitator

Whirlpool lists agitator and impeller configurations; use the supplied instructions when changing configuration.

Official source: Whirlpool Corporation — Official Whirlpool product page.

Quick Wash and Extra Rinse

Whirlpool describes Quick Wash for a small, lightly soiled load and offers two Extra Rinse options. Its 30-minute claim is based on a 3-lb load; do not treat that as a fixed cycle time.

Official source: Whirlpool Corporation — Official Whirlpool product page.

Maintenance and cleaning

Clean Washer with affresh

Whirlpool recommends running this cycle every 30 washes with an affresh washer cleaner tablet or liquid chlorine bleach; follow the product instructions.

Official source: Whirlpool Corporation — Official Whirlpool product page.

Symptom-by-symptom checks

Lid appears locked

  1. A lock during load sensing can be normal; do not force the lid.
  2. Use Start/Pause and wait for the lock to release as directed by Whirlpool.

If it persists: If the lid does not release after the documented procedure, contact Whirlpool service.

Official source: Whirlpool Corporation — Official Whirlpool product page.

Whirlpool WTW5057LW: space and setting FAQs

WTW5057LW is the cited U.S. top-load washer. Whirlpool's dimensions vary with the leveling-foot position; use the complete rating-label model and the supplied instructions for the final installation.

How large is the washer cabinet?

Whirlpool's W11428629 planning guide lists 27 3/4 in width and 27 in depth. Overall height ranges from 41 1/2 to 42 1/4 in with the feet setting. Whirlpool W11428629 dimension guide, product dimensions.

How high must a shelf be to clear the open lid?

The guide lists 55 3/4 to 56 3/8 in with the lid open, depending on leveling. A 57-inch shelf leaves only 5/8 in above the maximum listed height, a calculated gap rather than a usable loading allowance. Whirlpool W11428629 dimension guide, lid-open drawing.

Is 27 inches enough closet depth?

No. Twenty-seven inches is the washer body depth. The recessed-area diagram, rear hose and drain route, ventilation and service access must be checked separately. Whirlpool W11428629 dimension guide, recessed-area drawing.

What electrical supply does the planning guide call for?

The guide lists 120 V AC, 60 Hz and a minimum 15 A circuit. Follow the complete installation instructions and local code for the outlet and connection. Whirlpool W11428629 dimension guide, electrical requirements.

Does Deep Water set a fixed waterline?

No. Whirlpool describes Deep Water as an option that adds water to help loosen soil. Availability changes with the chosen cycle; on Bulky Items it cannot be turned off, according to the cited cycle guide. Whirlpool model support and cycle guide.

Does PreSoak keep Quick Wash short?

No. PreSoak adds a 30-minute soak before washing. If the combination is available for the selected load, it adds time rather than preserving the shortest Quick Wash plan. Whirlpool model support and cycle guide.

Does removing the agitator change exterior fit?

The removable agitator changes the basket's loading arrangement, not the cabinet dimensions or lid-open height used in the planning guide. Whirlpool product page and dimension guide.

Sources and scope

Reviewed October 7, 2026 by KBV Home Reference Editorial. This is a manufacturer-document reference, not a hands-on product test. Match the full model number and the instructions supplied with your appliance.

Similar Posts

Leave a Reply

Your email address will not be published. Required fields are marked *